Built-in voltage-boost compensation circuit and algorithm maintains constant torque during operation. Driver supply voltage DC 6–40 VDC; 12/24/36 V recommended. At 12 VDC input the internal voltage boosts to 32 V; at 24 VDC, to 36 V; at 36 VDC, to 44 V. Additionally, when the output current is set below 2 A (peak), the driver can start from 6 VDC, boosting internally to 28 V

Built-in back-EMF absorption circuit and algorithm dissipates the back-EMF generated during motor operation

Built-in brake control, alarm signal output, etc.

DIP switches select single-pulse, dual-pulse,internal IO pulse generation and potentiometer analog control

Brand-new 32-bit DSP technology, ultra-low vibration and noise Reverse-polarity protection: reversed voltage will not damage the driver

Reverse-polarity protection: reversed voltage will not damage the driver

Compatible with frames 20/28/35/39/42/57/60 full range of open-loop motors

Current output adapts to load changes Maximum continuous output current 5.6A

Accepts differential and single-ended pulse/direction/free commands

Maximum pulse frequency up to 500 kHz (factory default 200 kHz)

Pulses per revolution (microstep) set via software or DIP switches, range 200-51200

Internal IO pulse speed or potentiometer speed set via software or DIP switches, range 1–1500 RPM

Pulse, direction and free input signal level: 5–24 V compatible; interfaces accepting only 5 V signals available on request

Over-voltage, under-voltage, over-current, encoder-deviation and torque protection

With Mini-USB8 serial TTL (RS232 Modbus) debugging with our dedicated cable and software; fully isolated RS485 control circuit reserved